Reznor EEDU Unit Installation Manual Uživatelský manuál stáhnout pdf (Strana 31)

Form I-EEDU, P/N 150492 R6, Page 31

FIGURE 29 - Discharge

Air End of the Heat

Exchanger showing the

Bafe Assembly to be

Removed

Conversion is complete for Sizes 75-100; skip to Step 4.

3. Sizes 125-400 only - Remove the Side Finger Bafes – Refer to FIGURE

30 showing the entering air side of the heat exchanger (bafes shown

in FIGURE 29 have already been removed). Identify the side nger bafes.

Remove both side bafes; each bafe is attached with two screws.

Remove the support

bracket screws and slide

the bafe assembly out

of the heat exchanger.

Replace the screws to

plug the holes.

Bafes (Remove

with the supports

as an assembly.)

Conversion is complete for Sizes 125-400; continue to Step 4.

4. Select a location adjacent to the rating plate for the conversion label. Being sure

the surface is clean and dry, adhere the conversion label that was completed in

Step 1.

Test for proper operation. Be sure to comply with the air throughputs in the table on

page 30.

FIGURE 30 - Entering

Air End of the Heat

Exchanger showing the

Side Finger Bafes to

be Removed

Remove the two

screws from each

of the side nger

bafes. Remove both

bafes.

Heat exchanger side

nger bafes being

removed (Sizes 125-

400).

NOTE: Do NOT remove

these side nger bafes

on Size 75 and 100.

1 2 ... 26 27 28 29 30 31 32

Komentáře k této Příručce

Žádné komentáře

Reznor EEDU Unit Installation Manual Uživatelský manuál Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Radiátory Reznor EEDU Unit Installation Manual