Reznor EEDU Unit Installation Manual Uživatelský manuál stáhnout pdf (Strana 30)

Form I-EEDU, Page 30

APPENDIX

Converting Model EEDU Duct Furnace for Lower

Temperature Rise and Higher CFM Application

NOTE: If airow is being

reversed or other eld-

installed options apply, refer

to the other information

in Paragraph 3.2 before

performing this conversion.

FIGURE 28 - Fill in the

information on the

Conversion Label

Description/Application

2. Remove the Heat Exchanger Bafes - Refer to FIGURE 29 and identify the air

bafes to be removed. Remove the screws from the support brackets and slide the

entire bafe assembly out of the heat exchanger. Reinstall the screws to plug the

holes.

This Reznor duct furnace was factory assembled with the air throughput range listed

on the rating plate. The conversion in these instructions will change the air throughput

range as specied in the table below.

Model and

Size

High Air Throughput (CFM)

MAXIMUM MINIMUM

EEDU 75-6 2778 855

EEDU 100-6 3704 1140

EEDU 125-6 4630 1425

EEDU 140-6 5185 1595

EEDU 170-6 6296 1937

EEDU 200-6 7407 2279

EEDU 225-6 8333 2564

EEDU 250-6 9259 2849

EEDU 300-6 11111 3175

EEDU 350-6 12963 3704

EEDU 400-6 14815 4233

Verify the size on the heater rating plate. After conrming that this conversion is correct

for the unit, follow the instructions below.

1. Fill in the Field Conversion Label - Remove the conversion label, P/N 263310,

from the literature bag. Complete the information.

(date)

(name & address of company making this conversion)

263308

WARNING

This conversion shall be done by a qualied service agency in accordance with the manufacturer’s

instructions and all applicable codes and requirements of the authority having jurisdiction. If the

information in these instructions is not followed exactly, a re, explosion or production of carbon

monoxide may result causing property damage, personal injury or loss of life. The qualied service

agency performing this work assumes responsibility for the conversion of this appliance to provide

for higher CFM.

WARNING

The instructions in this sheet are designed to prepare a Reznor duct furnace for increased air

throughput conversion prior to installation. If your duct furnace is installed, for your safety, turn off

the gas and the electric before servicing.

1 2 ... 25 26 27 28 29 30 31 32

Komentáře k této Příručce

Žádné komentáře

Reznor EEDU Unit Installation Manual Uživatelský manuál Strana 30

Komentáře k této Příručce

Související produkty a manuály pro Radiátory Reznor EEDU Unit Installation Manual