Reznor VPS Unit Installation Manual Uživatelský manuál stáhnout pdf (Strana 17)

Typical usage of optional bend kits:

2.2.9 Detailed Assembly Drawings

The following pages show the technical

dimensional details of the range of heaters.

Please note the heater type, length and

reference number from the delivery/advice note

before identifying the correct model drawing.

2.2.6 End Caps (optional)

Position an end cap beneath the reflector

profile (where required) with the end cap

flanges facing inwards. Fasten to reflector

using the four ’Z’ clips.

2.2.7 Bend(s) (where fitted)

The heater can be installed with 1 or 2 90°

bends or a 180° U bend.

Slide the bend into the open end of the

coupler ensuring that the screw stop has butted

up to the tube ends. Refer to 2.2.4 for

fastening.

2.2.8 Burner/Fan Assembly.

Slide the burner assembly onto the open tube

end, ensuring it is fully engaged. Secure with

set screws.

For the purpose of unvented applications, a 4”

90° elbow should be used on the terminating

end of the radiant tube sections. This elbow

should be turned with the outlet facing either

side.

Connect Gas and Electrical supplies as

described in sections 1.4 and 1.5.

90° Bend

End Caps

Corner reflector

End Caps

16” crs

15”

U Bend

Corner reflectors (optional)

ASSEMBLY

REFLECTORS

BURNER

End Cap

Corner reflectors kit

90° Elbow

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Reznor VPS Unit Installation Manual Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Radiátory Reznor VPS Unit Installation Manual